ZORLANGALUMINUM

Market

March 2025: US aluminium tariffs return to 25% with no country exemptions

The Section 232 aluminium duty was restored to 25% and extended to derivative products, ending the quota deals that had softened it since 2018. What it did to trade flows.

On 12 March 2025 the United States restored the Section 232 aluminium tariff to 25% and removed the country-specific exemptions, quotas and product exclusions that had softened the measure since 2018. The same proclamation extended duties to a longer list of derivative aluminium products.

What was different this time

The 2018 version of Section 232 was porous. Canada and Mexico had quotas; the EU, Japan and the UK had negotiated arrangements; and thousands of product exclusions had been granted. By 2024 a large share of US aluminium imports entered at effective rates well below 25%.

The 2025 version closed those gaps:

  • No country carve-outs at the metal level (a separate arrangement for the UK persisted for a period).
  • Derivatives covered. Extrusions, sheet, strand, cable and a widening list of finished articles were brought into scope, so routing aluminium through a downstream product no longer avoided the duty.
  • No exclusion process of the earlier kind.

What it did to the market

  • The US Midwest premium rose and stayed elevated, because the duty is paid on delivery into the US and is recovered through the premium.
  • Canadian supply re-routed where it could. Canada is the largest single supplier to the US; where the duty applied, volumes were redirected or absorbed at lower margins.
  • Global prices were largely unaffected. The US is a premium market, not the marginal buyer. Removing metal from it did not tighten the world.
  • Asian and European exporters re-focused. The US became a harder market to serve from China, and attention shifted further toward the EU, Middle East, Southeast Asia and Latin America.

What it means for buyers

  • US landed cost is dominated by the premium, not the LME. A US buyer's aluminium exposure is roughly LME plus Midwest premium plus duty. Hedging only the LME hedges the smallest moving part.
  • Check whether your part is a "derivative". The classification determines the duty. Two similar parts can face very different treatment based on how they are described and entered.
  • Consider first-country transformation carefully. The substantial transformation test for duty purposes is not the same as the origin test for other regulations.
  • Price the market you are actually selling into. For exporters, the practical decision is whether a destination can absorb the duty at all. For much of the aluminium product range, the answer shifted to non-US markets.

Where it points

March 2025 re-established the US as a structurally premium, structurally restricted market. Three months later the rate doubled again to 50%, confirming that the direction was escalation rather than negotiation.

See 5052 plate and 6061 plate for products most exposed to derivative-product classifications.

Data sources

  • US Presidential Proclamation adjusting the aluminium derivative article duties, February 2025
  • US Federal Register tariff schedules, March 2025
  • US Geological Survey aluminium import statistics, 2024
  • LME aluminium official prices, March 2025

Related

All news