5052 H32 Aluminium Plate, Bar, Tube, Coil, Profile — GB/T 3880 · ASTM B209
5052 is the highest-strength non-heat-treatable alloy in common supply: 2.2–2.8% magnesium gives roughly 215–275 MPa tensile in H32, with excellent fatigue and corrosion behaviour in salt water. It is the default for marine hardware, fuel tanks, pressure vessels and transport panels. We roll it from 0.3 mm to 150 mm and can anodise or PVC-coat in-house.
Aluminium plate & sheetAluminium bar & rodAluminium tube & pipeAluminium coilAluminium profile
Specifications
Values per mill test certificate; tolerances to the standard named on this page unless agreed otherwise.
| Alloy | 5052 |
|---|---|
| Series | 5xxx |
| Temper | H32 |
| Standard | GB/T 3190 / GB/T 3880 / ASTM B209 / EN 485-2 / GB/T 6892 |
| Thickness | 0.2 – 150 mm |
| Width | up to 2,650 mm |
| Length | up to 12,000 mm |
| Surface | Mill finish · PVC coated · Anodised |
| Density | 2.68 g/cm³ |
| Melting range | 607 – 650 °C |
Other tempers on request
Melting range is the typical solidus–liquidus interval for the grade.
Chemical composition
Typical limits to ASTM / EN for the alloys we roll and extrude.
| Element | % |
|---|---|
| Mg | 2.2 – 2.8 |
| Cr | 0.15 – 0.35 |
| Cu | 0.10 max |
| Si | 0.25 max |
| Al | remainder |
Mechanical properties
Typical values at room temperature for the temper shown.
| Property | Value |
|---|---|
| Tensile strength Rm | 230 MPa |
| Yield strength Rp0.2 | 195 MPa |
| Elongation A | 12 % |
| Hardness | 60 HBW |
How it compares
The two alloys buyers most often shortlist against this one.
| Property | 5052 | 3003 | 5083 |
|---|---|---|---|
| Tensile strength Rm | 230 MPa | 150 MPa | 305 MPa |
| Yield strength Rp0.2 | 195 MPa | 145 MPa | 215 MPa |
| Elongation A | 12 % | 8 % | 16 % |
| Hardness | 60 HBW | 40 HBW | 70 HBW |
| Density | 2.68 g/cm³ | 2.73 g/cm³ | 2.66 g/cm³ |
3003 is more formable and cheaper; 5052 is about 50% stronger and far better in salt water. The switch is normally driven by strength or marine exposure. 5083 raises magnesium to 4.5% for welded marine structures and pressure vessels. It needs H116/H321 temper control and costs more; 5052 covers most sheet-metal work.
Process and quality control
Magnesium and chromium are verified per heat. Tensile and bend tests run on every batch, and salt-spray or intergranular corrosion testing is available for marine orders.
Packing
Certification and reports
Mill test certificate per heat, dimensional inspection report, and SGS or BV third-party inspection on request. Certificates travel with the shipping documents.
PDF, 1 page, generated from the data on this page.