ZORLANGALUMINUM

6063 T5 Aluminium Plate, Bar, Tube, Profile — GB/T 3880 · ASTM B209

6063 is the extrusion alloy: lower strength than 6061 but far better surface finish after anodising, which is why window systems, curtain wall, heat sinks and machine guarding are all made from it. We extrude from 0.3 kg/m to 30 kg/m, hold tolerance to EN 755-9, and finish in-house with anodising or powder coating.

Aluminium plate & sheetAluminium bar & rodAluminium tube & pipeAluminium profile

6063 — Window and curtain wall profiles
Application reference · 6063 T5 · 1 / 4

Main applications

Where this grade is used in series production, as listed in our alloy data sheet.

  • Window and curtain wall profiles
  • Handrails and balustrades
  • Heat sinks
  • Decorative profiles

Specifications

Values per mill test certificate; tolerances to the standard named on this page unless agreed otherwise.

Alloy6063
Series6xxx
TemperT5
StandardGB/T 3190 / GB/T 3880 / ASTM B209 / EN 485-2 / GB/T 6892
Thickness0.8 – 20 mm wall
Widthup to 400 mm section
Lengthup to 12,000 mm
SurfaceMill finish · Anodised · Powder coated
Density2.70 g/cm³
Melting range585 – 655 °C

Other tempers on request

Melting range is the typical solidus–liquidus interval for the grade.

Chemical composition

Typical limits to ASTM / EN for the alloys we roll and extrude.

Element%
Mg0.45 – 0.90
Si0.20 – 0.60
Fe0.35 max
Cu0.10 max
Alremainder

Mechanical properties

Typical values at room temperature for the temper shown.

PropertyValue
Tensile strength Rm175 MPa
Yield strength Rp0.2130 MPa
Elongation A12 %
Hardness60 HBW

How it compares

The two alloys buyers most often shortlist against this one.

Property60636005A6061
Tensile strength Rm175 MPa290 MPa310 MPa
Yield strength Rp0.2130 MPa240 MPa275 MPa
Elongation A12 %10 %12 %
Hardness60 HBW90 HBW95 HBW
Density2.70 g/cm³2.70 g/cm³2.70 g/cm³

6005A is a little stronger than 6063 and common in European curtain wall. Where EN 755-2 calls for 6005A, we can quote it; 6063 remains the faster, cheaper route for standard sections. 6061 is 30–40% stronger and machines better, but extrudes into simpler shapes and anodises less evenly. For a loaded machined part choose 6061; for a visible profile choose 6063.

Process and quality control

Profile dimensions are checked against the drawing before finishing, and anodic film thickness is measured on every rack. Coating adhesion is tested by impact and bend, with colour measured against the approved sample.

Packing

Export packing

Certification and reports

Mill test certificate per heat, dimensional inspection report, and SGS or BV third-party inspection on request. Certificates travel with the shipping documents.

Download spec sheet (PDF)

PDF, 1 page, generated from the data on this page.

All grades