1100 O Aluminium Plate, Bar, Tube, Coil, Foil — GB/T 3880 · ASTM B209
1100 is 99.0% pure aluminium with a controlled copper addition. That small addition lifts strength and machinability above 1050 while keeping conductivity high and formability excellent, which is why it is the default for spun, drawn and rolled parts that also get trimmed or punched. Supplied from 0.3 mm to 100 mm, in O, H14, H24 and H18.
Aluminium plate & sheetAluminium bar & rodAluminium tube & pipeAluminium coilAluminium foil
Specifications
Values per mill test certificate; tolerances to the standard named on this page unless agreed otherwise.
| Alloy | 1100 |
|---|---|
| Series | 1xxx |
| Temper | O |
| Standard | GB/T 3190 / GB/T 3880 / ASTM B209 / EN 485-2 / GB/T 6892 |
| Thickness | 0.2 – 4.0 mm |
| Width | up to 2,650 mm |
| Length | coil ID 508 mm · 2 – 8 t |
| Surface | Mill finish · Coated · Slit to width |
| Density | 2.71 g/cm³ |
| Melting range | 643 – 657 °C |
Other tempers on request
Melting range is the typical solidus–liquidus interval for the grade.
Chemical composition
Typical limits to ASTM / EN for the alloys we roll and extrude.
| Element | % |
|---|---|
| Al | 99.00 min |
| Si+Fe | 0.95 max |
| Cu | 0.05 – 0.20 |
| Mn | 0.05 max |
| Zn | 0.10 max |
Mechanical properties
Typical values at room temperature for the temper shown.
| Property | Value |
|---|---|
| Tensile strength Rm | 90 MPa |
| Yield strength Rp0.2 | 35 MPa |
| Elongation A | 35 % |
| Hardness | 28 HBW |
How it compares
The two alloys buyers most often shortlist against this one.
| Property | 1100 | 1050 | 3003 |
|---|---|---|---|
| Tensile strength Rm | 90 MPa | 80 MPa | 150 MPa |
| Yield strength Rp0.2 | 35 MPa | 35 MPa | 145 MPa |
| Elongation A | 35 % | 35 % | 8 % |
| Hardness | 28 HBW | 25 HBW | 40 HBW |
| Density | 2.71 g/cm³ | 2.71 g/cm³ | 2.73 g/cm³ |
1050 is purer and slightly more conductive; 1100 is stronger and machines better. If the part is punched or turned after forming, 1100 usually wins. 3003 is the stronger, more corrosion-resistant option, but it anodises less brightly. Keep 1100 where surface appearance matters.
Process and quality control
Each heat is spectro-checked and the coil is slit to the ordered width in-house. Surface is inspected under raking light for roll marks and inclusions, and thickness is logged every 20 metres.
Packing
Certification and reports
Mill test certificate per heat, dimensional inspection report, and SGS or BV third-party inspection on request. Certificates travel with the shipping documents.
PDF, 1 page, generated from the data on this page.