2011 T3 Aluminium Bar, Tube — GB/T 6892 · ASTM B221
2011 is the free-machining grade: 5.0–6.0% copper with bismuth and lead additions that break the chip, so automatic lathes run fast without stringy swarf. Typical T3 properties are 380 MPa tensile and 295 MPa yield at 15% elongation, roughly three times the strength of 6063, and machined faces come off bright. Supplied as round bar and tube, saw-cut or cut to length.
Aluminium bar & rodAluminium tube & pipe
Specifications
Values per mill test certificate; tolerances to the standard named on this page unless agreed otherwise.
| Alloy | 2011 |
|---|---|
| Series | 2xxx |
| Temper | T3 |
| Standard | GB/T 3190 / GB/T 6892 / ASTM B221 / EN 755-2 / ASTM B211 |
| Thickness | Ø 6 – 300 mm |
| Width | 60 – 600 mm |
| Length | 3,000 – 6,000 mm |
| Surface | Mill finish · Turned · Anodised |
| Density | 2.83 g/cm³ |
| Melting range | 540 – 630 °C |
Other tempers on request
Melting range is the typical solidus–liquidus interval for the grade.
Chemical composition
Typical limits to ASTM / EN for the alloys we roll and extrude.
| Element | % |
|---|---|
| Cu | 5.0 – 6.0 |
| Bi | 0.20 – 0.60 |
| Pb | 0.20 – 0.60 |
| Fe | 0.70 max |
| Si | 0.40 max |
| Al | remainder |
Mechanical properties
Typical values at room temperature for the temper shown.
| Property | Value |
|---|---|
| Tensile strength Rm | 380 MPa |
| Yield strength Rp0.2 | 295 MPa |
| Elongation A | 15 % |
| Hardness | 110 HBW |
How it compares
The two alloys buyers most often shortlist against this one.
| Property | 2011 | 6061 | 2017 |
|---|---|---|---|
| Tensile strength Rm | 380 MPa | 310 MPa | 425 MPa |
| Yield strength Rp0.2 | 295 MPa | 275 MPa | 275 MPa |
| Elongation A | 15 % | 12 % | 22 % |
| Hardness | 110 HBW | 95 HBW | 105 HBW |
| Density | 2.83 g/cm³ | 2.70 g/cm³ | 2.79 g/cm³ |
Process and quality control
Typical properties are verified heat by heat: spectrometric composition on every melt, tensile and yield on every cast, hardness and dimensional checks before packing. A mill test certificate, dimensional report and third-party inspection (SGS or BV) are issued against the heat number.
Packing
Certification and reports
Mill test certificate per heat, dimensional inspection report, and SGS or BV third-party inspection on request. Certificates travel with the shipping documents.
PDF, 1 page, generated from the data on this page.