3004 H32 Aluminium Plate, Tube, Coil — GB/T 3880 · ASTM B209
3004 adds about 1% magnesium to the 3003 base, lifting tensile strength from 150 to 215 MPa in H32 while keeping the same corrosion behaviour and weldability. That balance is why it dominates profiled roofing and wall cladding, and why chemical tanks and lighting columns are often built from it. Supplied as sheet, coil and tube.
Aluminium plate & sheetAluminium tube & pipeAluminium coil
Specifications
Values per mill test certificate; tolerances to the standard named on this page unless agreed otherwise.
| Alloy | 3004 |
|---|---|
| Series | 3xxx |
| Temper | H32 |
| Standard | GB/T 3190 / GB/T 3880 / ASTM B209 / EN 485-2 / GB/T 6892 |
| Thickness | 0.2 – 150 mm |
| Width | up to 2,650 mm |
| Length | up to 12,000 mm |
| Surface | Mill finish · PVC coated · Anodised |
| Density | 2.72 g/cm³ |
| Melting range | 629 – 654 °C |
Other tempers on request
Melting range is the typical solidus–liquidus interval for the grade.
Chemical composition
Typical limits to ASTM / EN for the alloys we roll and extrude.
| Element | % |
|---|---|
| Mn | 1.0 – 1.5 |
| Mg | 0.8 – 1.3 |
| Cu | 0.25 max |
| Al | remainder |
Mechanical properties
Typical values at room temperature for the temper shown.
| Property | Value |
|---|---|
| Tensile strength Rm | 215 MPa |
| Yield strength Rp0.2 | 170 MPa |
| Elongation A | 10 % |
| Hardness | 55 HBW |
How it compares
The two alloys buyers most often shortlist against this one.
| Property | 3004 | 3003 | 3104 |
|---|---|---|---|
| Tensile strength Rm | 215 MPa | 150 MPa | 285 MPa |
| Yield strength Rp0.2 | 170 MPa | 145 MPa | 260 MPa |
| Elongation A | 10 % | 8 % | 3 % |
| Hardness | 55 HBW | 40 HBW | 85 HBW |
| Density | 2.72 g/cm³ | 2.73 g/cm³ | 2.72 g/cm³ |
Process and quality control
Typical properties are verified heat by heat: spectrometric composition on every melt, tensile and yield on every cast, hardness and dimensional checks before packing. A mill test certificate, dimensional report and third-party inspection (SGS or BV) are issued against the heat number.
Packing
Certification and reports
Mill test certificate per heat, dimensional inspection report, and SGS or BV third-party inspection on request. Certificates travel with the shipping documents.
PDF, 1 page, generated from the data on this page.