4032 T6 Aluminium Bar — GB/T 6892 · ASTM B221
4032 carries 11–13.5% silicon, which brings thermal expansion down to roughly 80% of 6061 and gives strong wear resistance against a cylinder bore; nickel and copper hold strength at operating temperature. T6 gives 380 MPa tensile, 315 MPa yield and about 120 HBW. Supplied as forging bar, cut to billet length.
Aluminium bar & rod
Specifications
Values per mill test certificate; tolerances to the standard named on this page unless agreed otherwise.
| Alloy | 4032 |
|---|---|
| Series | 4xxx |
| Temper | T6 |
| Standard | GB/T 3190 / GB/T 6892 / ASTM B221 / EN 755-2 |
| Thickness | Ø 6 – 300 mm |
| Width | 60 – 600 mm |
| Length | 3,000 – 6,000 mm |
| Surface | Mill finish · Turned · Anodised |
| Density | 2.69 g/cm³ |
| Melting range | 555 – 585 °C |
Other tempers on request
Melting range is the typical solidus–liquidus interval for the grade.
Chemical composition
Typical limits to ASTM / EN for the alloys we roll and extrude.
| Element | % |
|---|---|
| Si | 11.0 – 13.5 |
| Cu | 0.5 – 1.3 |
| Mg | 0.8 – 1.3 |
| Ni | 0.5 – 1.3 |
| Al | remainder |
Mechanical properties
Typical values at room temperature for the temper shown.
| Property | Value |
|---|---|
| Tensile strength Rm | 380 MPa |
| Yield strength Rp0.2 | 315 MPa |
| Elongation A | 5 % |
| Hardness | 120 HBW |
How it compares
The two alloys buyers most often shortlist against this one.
| Property | 4032 | 4045 | 6061 |
|---|---|---|---|
| Tensile strength Rm | 380 MPa | 120 MPa | 310 MPa |
| Yield strength Rp0.2 | 315 MPa | 55 MPa | 275 MPa |
| Elongation A | 5 % | 20 % | 12 % |
| Hardness | 120 HBW | 35 HBW | 95 HBW |
| Density | 2.69 g/cm³ | 2.70 g/cm³ | 2.70 g/cm³ |
Process and quality control
Typical properties are verified heat by heat: spectrometric composition on every melt, tensile and yield on every cast, hardness and dimensional checks before packing. A mill test certificate, dimensional report and third-party inspection (SGS or BV) are issued against the heat number.
Packing
Certification and reports
Mill test certificate per heat, dimensional inspection report, and SGS or BV third-party inspection on request. Certificates travel with the shipping documents.
PDF, 1 page, generated from the data on this page.